2 Interace WAN
Hi ,
I have 2 Interfaces WAN to acces on external , however , all my LAN are configured to pass through the WAN 1 to acces internet ,
How I can use one of my VLAN or one my Host to pass throigh the WAN 2 Interface to acces internet (or extrenal IP adresse)
Regards
Tovo
0
Sign In to comment.
Comments
You can use SD-WAN on policies to select the WAN interface to be used for that traffic.
So add policies From: the VLAN etc. and use SD-WAN to select WAN 2 as the primary WAN.
I ve tryed to do that but my OS version of the Firebox does'not support the used of SD WAN Actions for Policys routing
What OS version are you running?
Does it support Policy Based Routing?
I use Watchguard M470 with FireWire OS V11.6.3
I suppose , it support because on my policy add i have chechbox to select what Route outbound trafic using : Policy Based routing or SD WAN
You can use Policy Based Routing on a policy to select which WAN interface to use as the primary.
SD-WAN is for V12.3 and higher.
Policy Based Routing is for lower versions.
Ah ok, i used Policy Based Routing , and add WAN 2 interaface on my policy but the route used wtih my tracert seems always the WAN 1
Do you have PBR selected on the policy which is allowing your traceroute ??????? Probably a ping policy.
On what policy have you selected PBR ?
Yes directly on ping policy
Turn on Logging on this policy & post an allow log message from Traffic Monitor showing that it is going out WAN 1
What have you set for Multi-WAN ?
Is WAN 2 up ?
Yes WAN 2 is up , and for multiwan we use Routing Table
It'OK now, I put Routing Table on both policy , https and ping