Vlan through Site to Site VPN

kcarpenterkcarpenter
in Firebox - Networking, Multi-Wan, VLAN, NAT, SD-WAN

I have a site to site vpn that is working fine. I am adding a vlan for the wireless network at site B. I want all traffic to go through Site A. When I try and add the new vlan to the tunnel it breaks the vpn. I do have it working by use Nat for the vlan, but I don't want that. Currently the tunnel at site B is setup like This.
Site B
Local: 192.168.68.0/23
Remote: Any IPv4
Direction: Bi-directional.

Site A
Local: Any
Remote: 192.168.68.0/23
Direction: bi-directional

My new Vlan is 192.168.168.0/24
Using Nat does work. But how would add this to the tunnel for bi-directional?
If I add it like the other network it breaks the vpn.

Comments

  • kcarpenterkcarpenter

    Well scratch that. I just tried again and it seems to be working. The tunnel is up and staying up. Not sure why I was having so many issues before.

  • james.carsonjames.carson Moderator, WatchGuard Representative

    Hi @KevCar
    It's super easy to make a typo, but unfortunately all of those items are required for an IPSEC tunnel.

    I'd suggest just keeping an eye on it and seeing how it goes over a few days.

    -James Carson
    WatchGuard Customer Support

Sign In to comment.