Dynamic Nat Pool

mtavukcuoglumtavukcuoglu
edited February 7 in Firebox - Other

Hello Friends

I want to export a device on Watchguard (172.16.16.16.100) with my ip addresses with /29 subnet attached to my firewall device.

How can I create a pool and assign 10 ip over this subnet?
How can I use not one ip but 10 different ip addresses in a pool to get ip from this pool when accessing the internet.

Thank you in advance for your support.

Note: /29 subnet is attached as a secondary address.

Comments

  • Bruce_BriggsBruce_Briggs

    You can set up 1-to-1 NAT entries for these, which would allow Internet access to up to 10 internal devices via those public IP addrs.

    You can use SNAT with these IP addrs, to Internet access to internal devices via those public IP addrs.

    You can set up Dynamic NAT entries From: a specific internal IP addr To: Any-external, and specify one of these IP addrs on the Set Source IP field.

    On policies, on the Advanced tab, you can specify an external IP addr to use including Secondary IP addrs for outgoing traffic that uses that policy.

    Note - one should not use the same IP addr for 1-to-1 NAT and for any of the other options above. And one does not need to have an IP addr used in a 1-to-1 NAT set as a secondary IP addr.

Sign In to comment.