Access vigor 130 webui

MWRobboMWRobbo
in Technical Discussion

Hoping somone can help.

I'd like to be able to access the web-ui of my draytek modem to check the DSL sync speed, erros etc.

Draytek Vigor 130 is running in bridge mode and connected to the watchguard.

At the moment the only way to access the modem web-ui is to disconnect the watchguard and connect a laptop directly to it with a static IP.

I'm guessing I need to setup static routes but its a little beyond my brain.

Modem has an IP of 192.168.2.1/24 and connected to watchguard WAN port. The watchguard WAN port is using PPPoE to auth on my broadband service so has a public static IP.

Is there a way to allow my clients on one of my VLans to be able to connect to the modem web-ui?
Lets say the clients are on a network of 192.168.30.0/24

Best Answer

  • Bruce_BriggsBruce_Briggs
    edited January 2022 Answer ✓

    Try this - assuming that 192.168.2.0/24 is not used in your config

    . add 192.168.2.2/24 as a Secondary IP addr on external
    . add a Dynamic NAT entry - From: Any To: 192.168.2.1; Set source IP addr = 192.168.2.2. Move this entry to the top of the Dynamic NAT list

    Let us know if this works.

Answers

  • MWRobboMWRobbo

    You sir, are a scholar and a gent!
    That worked perfectly. Thanks for taking the time to help me out.

Sign In to comment.