Comments
-
A simple solution to this. Watchguard can have up to 3 dhcp relays assigned. I run with 2 dhcp servers with failover. Add the 3 dhcp relay on the vlan where WDS, SCCM or whatever it is that an extra dhcp server and PXE Boot works
-
Hmm ok i Will try open a case then The for replay
-
Can i make a filter rule for that?
-
Hmm do i nede to make a static route from each vlan suppet to dhcp server?
-
Hi bruce_briggs i already have dhcp relay on them and it also works with the scopes i have on the dhcp server on domain. I had also counted on when you activated inter routing on xtm so you did not need any rules either. but dhcp relay does not take pxe over. everything else works like it should just not pxe boot?
-
just to open Neighbors / Discovery so it not show up as red block?
-
Hi Bruce_Briggs Thanks for the answer. PT I have to have Neighbors / Discovery on until I have got all the interplan and routings in place, so I would allow it in the firewall so it was not so red all the time but even if I allow the gate it still comes out? Regards Jimmy