PPoe secondary ip

Comments

• Bruce_Briggs

  October 2023

  Add an IP from this range as a secondary IP addr, and use it for your SSLVPN & BOVPN

  0
• james.carson

  October 2023

  You'll need to define the secondary IP on the interface that connects to your ISP device (your external interface.)

  See:
  https://www.watchguard.com/help/docs/help-center/en-US/Content/en-US/Fireware/networksetup/second_net_config_c.html

  Once that is configured, you can set the SSLVPN IP in the SSLVPN config to the secondary IP.

  0
• RobertoCostelli

  October 2023

  Thanks everyone for the replies.
  I tried entering the secondary ip address in both the form x.x.x.137/30 and x.x.x.137/32.
  It doesn't work and in the traffic log I see many blocks at addresses x.x.x.137, 136, 138,139

  0
• Bruce_Briggs

  October 2023

  You will see denies for incoming packets which do not match a policy allowing them.
  
  Exactly what doesn’t work?

  0
• RobertoCostelli

  October 2023

  Hi Bruce, this is an extract of trafic monitor...

  traficmon.txt 18.3K

  0
• Bruce_Briggs

  October 2023

  I see some outgoing allowed traffic and a lot of denied packets from the Internet.
  Nothing looks wrong to me.

  0
• RobertoCostelli

  October 2023

  Hi Bruce, i'm unable to connect with SSLVPN and also BOVPN not work.
  I can't ping the secondary ip address from internet.
  I don't know if i must configure somethings else in NAT or ROUTE...
  Thank's

  0
• Bruce_Briggs

  October 2023 edited October 2023

  You need a Ping policy to allow incoming pings - From: Any-external To: Firebox or a specific external IP addr.
  
  If you have a support license on your Firebox you can open a support case and get help from a WG rep with your issues.

  0
• Bruce_Briggs

  October 2023

  There are client logs on the SSLVPN app and you can turn on Diagnostic Logging for both SSLVPN and IPSec which may show something to help.

  0