how to debug bgp?

vanessavanessa
in Firebox - Networking, Multi-Wan, VLAN, NAT, SD-WAN

hello community,
i'm using bgp and want to manipulate the AS-Path from my internal network before exporting to an ebgp neighbor. no big deal i thought... but it's not working. I'm really missing any kind of bgp debugging possibilities, like a vtysh on cli. The only way i found to get bgp routes (with AS!) is from 'show status-report' somewhere in the middle of thousands of lines, but I can't imagine that this is the intended way? Even if i see the bgp routing table from the status-report, i don't see what i advertise...
how do you debug or monitor your bgp sessions?

Firebox M5800
Firmware v12.11.3

kind regards,
vanessa

Comments

  • james.carsonjames.carson Moderator, WatchGuard Representative

    Hi @vanessa

    If you just need to see your routes, you can do so via
    show ip route dynamic

    If you need debug information about what your firewall is advertising, you'll likely need to create a support case.

    -James Carson
    WatchGuard Customer Support

Sign In to comment.